priti®perfect

priti®perfect – Full Set

The perfect complement
for a lively surface finish


Staining and structural pastes

  • compact: highly aesthetic and fluorescent pastes, with only 20 components
  • effective: 1-firing solution is possible
  • controllable: Final colors are already evident during application
priti®perfect stands for:

The staining and structural pastes priti®perfect are the perfect complement for a lively surface finish. priti®perfect addresses the 1-firing solution. Nonetheless, and depending on the case, the 2-firing solution or internal staining can also be selected. The final colors are already evident during application.

Artikelnr: PPSETx Kategorier: ,

Beskrivning

Full set includes both Basic- and Effect set

Basic Set

  • PPSHAX shade A
  • PPSHBX shade B
  • PPSHCX shade C
  • PPSHDX shade D
  • PPSHWH color white
  • PPTRPI transpa-pigeon
  • PPSTCL structure clear
  • PPSTGL glaze
  • PPSTLI liquid

Effect set

  • PPSHRO color rose
  • PPSHBL color black
  • PPSHYE color yellow
  • PPSHCO color copper
  • PPSHFI fissure
  • PPTRBL transpa-blue
  • PPTRSM transpa-smoke
  • PPTROR transpa-orange
  • PPTRHA halo
  • PPSTDE structure deep
  • PPSTOP structure opal

 

APPROVED FOR:

  • Zirconium dioxide
  • Monolithic zirconium dioxide
  • Zirconia layered ceramics
  • Metal layered ceramics
  • Lithium disilicate

step-by-step to the perfect finish

You can find ideas for personal finalisation in these videos.

All information about the pastes can be found in this flyer.

A – PREPARATION

Condition the surface
1. Create the restoration as usual
2. Clean the surfaces
3. Treat surfaces with a little glaze/liquid mixture avoiding puddles.

 

B – SELECT PROCEDURE.

You can find more information on the procedures in the brochure

 

C – FINISH

Choose from two options:

a) Place the restoration in the furnace immediately. If necessary, finish and polish after firing.

b) When using structural pastes:

4. Keep briefly in ceramic furnace at 300 °C
5. Dry for 10 seconds
6. Finish surface with brush
7. Start firing program

 

D – FIRING

Each furnace is different, therefore the parameters need to be adjusted according to the desired gloss level of the surface.
The rate of increase, the final temperature and the holding time must be adjusted for larger objects (20-30 °C).

 

FIRING PARAMETERS

Standard firing parameters
Pre-drying3 min
Starting temperatur450 °C
Closing time4 min
Rate of increase40 °C/min
Starting vacuum670 °C
Final temperatur775 °C
Holding time1 min

Ytterligare information

Vikt1 kg
Dimensioner20 × 30 × 40 cm
Variant

Full Set, Basic Set, Effect Set

Relaterade produkter